benpalmer

benpalmer

Well-Known Member
Hi All,

Just had an MOT and unfortunately she failed! Couple of easy fixes but one that's got me scratching my head is the exhaust gas results.

It failed on Hydro Carbons - HC. The limit is 1200ppm and the test came back at 1475ppm

Anyone had this before? Anything to try before taking it back?

Thanks
 
I thought Strombergs were the standard, has it been upgraded? Is much rather have SUs any day :)
Have you checked they're not running rich? Is the engine getting fully to to temp?
 
kermit_rr said:
I thought Strombergs were the standard, has it been upgraded? Is much rather have SUs any day :)
Have you checked they're not running rich? Is the engine getting fully to to temp?
Click to expand...

From what I know these are standard, i think LR changed to SUs for the later V8 carb models.

I was about to have a look at mixture, but wanted to see if there is anything else to try first as I'm not particularly confident with it.

The engine get ups to temperature no problem.
 
The easy way to check your carbs are set, when it's up to temp, blip the throttle then let it idle a few seconds to stabilise. Lift the piston slightly and the engine revs should stay the same or rise ever so slightly. If there's no push under the carb then you can use a thin screwdriver down the inlet
 
High HC reading means the engine isn't burning all of the fuel , replace air filter , check and adjust mixture , balance carbs.......all thats assuming the compressions are good and dont forget the Italian tune up on the way to the testing station ........HTHs
 
With carbs I would be checking the needles move correctly. If these carbs have a diaphragm, pop the tops off and make sure there are no holes in the diaphragms. Check any choke mechanisms - make sure the choke is able to be fully off. If it's an automatic choke that works with a bi-metallic spring arrangement make sure the mechanism is correctly adjusted and works freely. HTH.
 
Thanks All,

I'll play around tomorrow, I took it for an "illegal" trip as it hadn't been run in a while so that may also help.
 
You must log in or register to reply here.

Similar threads

I
Fauls after reading with GAP IDD Tool - which one are 'real'?
Replies
19
Views
752
invisible999
I
Bife
Freelander 1 Oil Cooler
2
Replies
28
Views
2K
Bife
Bife
P
Fault finding Autobox Freelander 1 (V6)
2
Replies
20
Views
3K
felborba
felborba
Wagon Loon
300 tdi I gas flowed my new cylinder head, after head gasket fail, 97 Defender pick-up Peggy
2
Replies
33
Views
4K
Stanleysteamer
Stanleysteamer
MollyNomad
Freelander 1 HOLY (NON) SMOKES
Replies
4
Views
796
MollyNomad
MollyNomad