Garwillis

Garwillis

Active Member
Afternoon all I seem to have picked up a MAF sensor fault on my 2010 3.6 V8 RR ..the code comes up as Mass / Volume air flow B - circuit low
I've removed them and cleaned them with electro clean but to no avail, question is which one is B ? I've attached the readings ..
20190126_122817.jpg
[/GALLERY]
 
So after fitting a new MAF problem still there now just showing P007F air flow problem bank 1+2 correlation !!! Not great ..and So it goes on .....
 
Garwillis said:
So after fitting a new MAF problem still there now just showing P007F air flow problem bank 1+2 correlation !!! Not great ..and So it goes on .....
Click to expand...

Only thing i can think of in relation to that is that one MAF is showing a different flow rate than the other. Maybe you have an EGR valve stuck slightly open. Or an air leak after the MAF sensor.
 
Ok so both EGR valves replaced (one defective the other as a precaution due to access) £165 each, labour, gaskets and smoke test, +VAT ..£852 holy ****e !!!
 
Garwillis said:
Ok so both EGR valves replaced (one defective the other as a precaution due to access) £165 each, labour, gaskets and smoke test, +VAT ..£852 holy ****e !!!
Click to expand...

Bloody hell i'm good, don't know how i do it for the money. :D:D:D:D
 
Well at least it has a positive side. All those who did not have a bloody clue what was wrong, can now come on if it happens again in the future to anyone else, and claim they are clever and know the answer. :D:D
 
Last edited:
You must log in or register to reply here.

Similar threads

P
L322 Vogue 2006 4.4 V8 MAF/limp mode issues
Replies
9
Views
744
peterself
P
MAF Diver
Disco 2 Rough idle in a V8 D2a — tried MAF, O2, sparks, leads
2
Replies
35
Views
3K
marjon
marjon
JokerUK
Sport MAP/MAPT Sensors on 4.2 S/C
Replies
0
Views
858
JokerUK
JokerUK
M
Discovery 4 - Limp Mode Cold Start Manifold absolute pressure issues
Replies
2
Views
1K
Graculus
Graculus
Ashs1
D2 v8
Replies
11
Views
1K
sierrafery
sierrafery