S

sassanach

Well-Known Member

• Nov 1, 2011

• #1

does anyone what the pinouts on the ecu are for the lamda connections and also the rpm signal please?
perhaps i should add its a thor 2000x reg doh!!!

 

Last edited: Nov 1, 2011

rewmer

Well-Known Member

• Nov 1, 2011

• #2

Yes I do. Standby, I check my info and get back to you. My info is not to hand at the moment. It is a Thor engine isn't it ?

 

Last edited: Nov 1, 2011

S

sassanach

Well-Known Member

• Nov 2, 2011

• #3

anybody got any answers please? pretty please?

 

rewmer

Well-Known Member

• Nov 2, 2011

• #4

Sorry bud, meant to check for you but was distracted by becoming a grandad, yes, I know, ridiculus at my age I know. I will look when I get home, promise.

 

Irishrover

Well-Known Member

• Nov 2, 2011

• #5

Send me a PM with your email address and I will send you the THOR Ecu pinout info.

 

rewmer

Well-Known Member

• Nov 2, 2011

• #6

Found it. If your putting your gas ECU in the compartment behind the battery conviently vacated by the GEms ecu you can split the harness just behind this compartment. The rpm signal is a plain grey wire. The O2 sensors are B16 and B15. Depending on your system, these may not be necessary. Most advanced systems only use these for diagnostics in the LPG software.

 

S

sassanach

Well-Known Member

• Nov 3, 2011

• #7

where does the grey wire terminate in the ecu please?