P

philreed52

Member

• Nov 12, 2016

• #1

Evening all, spent an age searching for a camel cut guide and it's stressing me out.. does anyone know where I can find it? I'm just about to do mine but I wanna make sure I'm prepared beforehand....

Cheers

 

C

Critical Mick

Member

• Nov 13, 2016

• #2

 

P

philreed52

Member

• Nov 13, 2016

• #3

Thanks for your reply, it was moreso the rear doors that I'm looking for

Cheers

 

RichardH

Active Member

• Nov 14, 2016

• #4

philreed52 said:

Thanks for your reply, it was moreso the rear doors that I'm looking for

Cheers

Click to expand...

Camel cut is just a slight cut on the rear quarter. Cutting the rear doors is normally only done when you are fitting flexi arches.

 

P

philreed52

Member

• Nov 14, 2016

• #5

Aah ok thanks for your help guys. I'll see if I can find anything under fitting flexi arches cus that's what I'll be doing

 

StuRox

Well-Known Member

• Nov 15, 2016

• #6

just tape on the flexi arches, mark and cut away the metal for them to fit - only tip is be cautious when cutting - better to cut off a little, than too much.

You will be surprised how much metal you actual cut away - I was

 

P

philreed52

Member

• Nov 15, 2016

• #7

Thank you for your replies! I'm gonna fit the flexi arches as soon as I get them. The underside is in fairly good condition to be fair but next summer I'm gonna take off both rear quarters, cut the sills out and replace with box section and replace the pillar boots. I wanna get the whole thing as rot free as possible then treat it