Martin59
New Member
:multiply:Freel2.com - View topic - Suspension Lift Spacers
Hope this helps
Hope this helps
Optimus Prime
Well-Known Member
Am I the only one missing something here ?
SES88
Well-Known Member
yes there is
There's a PCD where all the centres of the holes are located, but no angles or dimensions to show the location in relation to each other
3 holes equidistant - 120 deg apart on one drwgThere's a PCD where all the centres of the holes are located, but no angles or dimensions to show the location in relation to each other
SES88
Well-Known Member
That's not how they look on the drawing i saw
The other drawing shows 3 holes as an equidistant triangle
SES88
Well-Known Member
the rear definitely isn't, and the front has nothing to denote that they're equally spaced...
If anything, on the front's the top hole looks bigger than the other two as well, pretty difficult to make something usable from those drawings I'd say!
whats it mate to - I assume the holes are to align with something else?
SES88
Well-Known Member
Top of the struts, same idea as my FL1 lift kits, but on them the spacing isn't equal between all the holes, neither front nor rear, so unlikely that the spacings will be equal on the FL2 either.
Best way for someone to make themselves a set of spacers is to get a front and rear strut and draw the pattern out, that way its guaranteed to fit first time
in that case, Sir, I bow to your superior knowledge.
The drawings are crap
The drawings are crap
SES88
Well-Known Member
print them out at what scale? your printer won't print 1mm distance as 1mm on the page
