nickp3003

Well-Known Member

• Oct 25, 2013

• #1

(Discovery 1)

Hi guys, just wondering if any body has had problems with there disco leaning to one side slightly?
Its leaning to the drivers side, the gap from the top of the wheel to the arch is about 1 inch larger on the passengers side,

is this usually down to crap suspension? and would a new kit with say a 2 inch lift all round sort it out?

Thanks as always!

 

S

somersetsparks

Active Member

• Oct 25, 2013

• #2

This happened to mine when the A- Frame ball joint went. First I tried replacing the springs (which helped a little but still a gap). Also stoped a nasty twitch on country roads.

 

nickp3003

Well-Known Member

• Oct 25, 2013

• #3

somersetsparks said:

This happened to mine when the A- Frame ball joint went. First I tried replacing the springs (which helped a little but still a gap). Also stoped a nasty twitch on country roads.

Click to expand...

Thanks for that its going in for a good sort out very soon (full service, and a shed load of welding) so ill get that looked at too,

 

Z

Zednero

New Member

• Oct 25, 2013

• #4

Are you overweight? Does this happen when you sit in it?

 

auf_wiedersehen_pet

Well-Known Member

• Oct 25, 2013

• #5

Zednero said:

Are you overweight? Does this happen when you sit in it?

Click to expand...

:hysterically_laughi:hysterically_laughi

 

Nigel-S

soft and furry

• Oct 25, 2013

• #6

Perhaps it used to belong to the 70 stone man

 

nickp3003

Well-Known Member

• Oct 25, 2013

• #7

Haha well being 6 ft 2 I am heavy, gonna convert it to left hand drive, should equal out after a few miles then, there again I can't be too heavy as I haven't fallen through the rusty floor yet...