wil2813
Well-Known Member
having similar issues as below which was posted on another site not a prob at moment but would rather get it sorted, any suggestions folks ?
"Hi All having a bit of a problem with my Rangie its a 2002 4.4 range rover with LPG. The energy management light came on today I plugged in a diagnostic computer and it had a few problems, the one that brought on the light was misfires. but there was also tank vent valve and Electronic thermostatic control. I also could not get the petrol cap off when trying to fill up (running on gas most of the time so use very little). I reset the codes and had a drive of about 12 miles when checked again the electronic thermostaic control and the tank vent valve were on again but no engine light. I believe I am getting a vac in the tank because of the valve giving me a misfire. Anyone had this problem and what is the repair.The thermostatic control code is 140 which in the manual says lambda is the computor wrong?"
prob a few will agree inc ant (saint) you will now & again get a eml light come on when lpg is fitted due to changeover but this tank vent etc is bugging me also I have no probs filling up with fuel & no tank pressure(air hissing) although I did notice the gun at filler station has been hard to fit into the filler neck on the last few occasions ?
thanks in advance will
"Hi All having a bit of a problem with my Rangie its a 2002 4.4 range rover with LPG. The energy management light came on today I plugged in a diagnostic computer and it had a few problems, the one that brought on the light was misfires. but there was also tank vent valve and Electronic thermostatic control. I also could not get the petrol cap off when trying to fill up (running on gas most of the time so use very little). I reset the codes and had a drive of about 12 miles when checked again the electronic thermostaic control and the tank vent valve were on again but no engine light. I believe I am getting a vac in the tank because of the valve giving me a misfire. Anyone had this problem and what is the repair.The thermostatic control code is 140 which in the manual says lambda is the computor wrong?"
prob a few will agree inc ant (saint) you will now & again get a eml light come on when lpg is fitted due to changeover but this tank vent etc is bugging me also I have no probs filling up with fuel & no tank pressure(air hissing) although I did notice the gun at filler station has been hard to fit into the filler neck on the last few occasions ?
thanks in advance will
Last edited: