blackburnbertie · Mar 2, 2018

Hi folks. My 2000 p38 has started to indicate a ‘ key in ignition ‘ after the key is taken out and I open the door. It doesn’t lock with the remote which I understand as the car thinks the key is still in the ignition, luckily it does lock manually. Any ideas ?

johnnyb70 · Mar 2, 2018

Spray a bit of oil in the ignition barrel whilst pushing the middle. Simpelz.

The Mad Hat Man · Mar 2, 2018

only use dry lubricant.

discool · Mar 2, 2018

The micro switch that operates and gives the indication the keys in the ignition switch is stuck in the make position therefore not releasing. Maybe.

Dippypud · Mar 2, 2018

The Mad Hat Man said:
only use dry lubricant.

blackburnbertie · Mar 2, 2018

The Mad Hat Man said:
only use dry lubricant.

What should I use silicon or graphite ?

Dippypud · Mar 2, 2018

blackburnbertie said:
What should I use silicon or graphite ?

The latter ...

Grrrrrr · Mar 2, 2018

blackburnbertie said:
What should I use silicon or graphite ?

Blast a load of electrical contact cleaner down there. Then squirt in some graphite powder. You can get 4 mini cans for about a fiver. You'll want to do all your locks afterwards and your seatbelt holder!

Revititllclear · Mar 2, 2018

I squirted some contact cleaner and then used an air line to force the crud out. A few goes and the problem appears resolved....for now.

Grrrrrr · Mar 2, 2018

Revititllclear said:
I squirted some contact cleaner and then used an air line to force the crud out. A few goes and the problem appears resolved....for now.

Perfect! A bit of graphite lube now and it'll stay away for a few years.

fucmeitsandy · Mar 2, 2018

Graphite powder is what I used , DO NOT FILL THE LOCK WITH IT , it's quite difficult getting it out so you can get the key in .!!
Other that that no problem since .

wammers · Mar 3, 2018

Revititllclear said:
I squirted some contact cleaner and then used an air line to force the crud out. A few goes and the problem appears resolved....for now.

That is exactly how you clean the barrel and micro switch lever out. A small amount of graphite powder completes the job.

Revititllclear · Mar 4, 2018

......I'm following the advice and adding a small amount of graphite powder....... had been wary as I thought it might "gunk" up.....

Grrrrrr · Mar 5, 2018

Revititllclear said:
......I'm following the advice and adding a small amount of graphite powder....... had been wary as I thought it might "gunk" up.....

The stuff in the little aerosols should be fine. great stuff.

blackburnbertie

Member

johnnyb70

Well-Known Member

The Mad Hat Man

Well-Known Member

discool

Well-Known Member

Dippypud

Never Knowingly Understood

blackburnbertie

Member

Dippypud

Never Knowingly Understood

Grrrrrr

Technician, Bodgit & Scarper Ltd

Revititllclear

Member

Grrrrrr

Technician, Bodgit & Scarper Ltd

fucmeitsandy

Well-Known Member

wammers

No longer with us, RIP

Revititllclear

Member

Grrrrrr

Technician, Bodgit & Scarper Ltd

Similar threads