Datatek
Well-Known Member
I don't see why not, it's not a special Land rover part, just a standard pressure switch.Sorry...its 'that' question again
Are the britpart ones OK?
cornishboater
Well-Known Member
Wot Keef saidSorry...its 'that' question again
Are the britpart ones OK?
@kurtjohnson10 had a pressure switch at one stage.
I think it has some sort of cement / sealant when it goes in too. Or maybe younuse that gas PTFE tape used on boilers?
I think it has some sort of cement / sealant when it goes in too. Or maybe younuse that gas PTFE tape used on boilers?
Datatek
Well-Known Member
NO sealant, just PTFE tape as used in plumbing.
kurtjohnson10
Well-Known Member
I have quite a few brand new pressure switches available, i use 577 loctite when fitting them. Gas pipe sealer level of quality
Flossie
Well-Known Member
Duchess slowly drops to her bump stops over about 5 days, sprayed everything with soapy water and can't see a leak anywhere, car was put into off road height whilst I did this. No air leaking from the exhaust silencer either, however when I disconnected the nylon pipe 8mm? Nearest the front of the valve block there was a lot of air released so I guess that's from the receiver? The 4 from the air bags, which I disconnected first had just a little puff left in them. Anyway, got a lazy day today and another pressure switch so fitted that and installed this unknown valve block to test it. Door open and it took 11 mins to fill the system which means a good compressor? It's very quiet running too. Shut the door and up she went.
So looks like a guddon.
Had a measure of arch heights and I'll see if it still drops over the next few days.
So looks like a guddon.
Had a measure of arch heights and I'll see if it still drops over the next few days.
