L

ldrego

Active Member

• May 4, 2016

• #1

could someone in the know tell me if this is an mot fail? It is on the rear leg of my discovery 2. I am assuming it will need to be repaired at some point if not immediately but if so, could it be plated?

 

R

ruffday

Active Member

• May 4, 2016

• #2

???????

 

Dan_Trials

Well-Known Member

• May 4, 2016

• #3

ruffday said:

???????

Click to expand...

Think the picture will be along shortly...

 

L

ldrego

Active Member

• May 4, 2016

• #4

Ahh the picture.

 

Attachments

• 
  image.jpeg

  832.9 KB · Views: 301

Marmaduke

Well-Known Member

• May 4, 2016

• #5

ldrego said:

Ahh the picture.

Click to expand...

I'd be attacking it with a wire brush to see exactly what you're looking at, personally cutting the rot out is better than plating over the top of it

 

L

ldrego

Active Member

• May 4, 2016

• #6

I don't mind attacking it later with an angle grinder / steel rotary wire combo but just now, need it just to get through the mot.

 

L

ldrego

Active Member

• May 4, 2016

• #7

The rust on top is not flaky at all , it is solid.

 

Marmaduke

Well-Known Member

• May 4, 2016

• #8

You should be fine then. You'll laugh when you see the size of the hammer the mot tester uses, it wouldn't break a lump of toffee

 

L

ldrego

Active Member

• May 4, 2016

• #9

This would take a good thrashing like to make a hole in that. I do need to investigate it further but not this week if you understand. My chassis protection stuff is just not working. I must have put so much man hours into it but just not getting there whatsoever. I will post up my box section repairs shortly and hopefully you can give me a little advise on whether they should pass. I was told at the previous mot place that these sections under the door sills were not structural hence gave them a shot with my welder.

 

stannswhite

Well-Known Member

• May 4, 2016

• #10

i suppose it depends on the m.o.t tester,if
it passes i think it will be down as an advisory.
i hope it passes for you mate.

 

L

ldrego

Active Member

• May 4, 2016

• #11

Hoping too. I would just like for once to get a clear run on the mot with this car. I was going to post the welding that I had done however the camera cannot focus that close.