anubis757

anubis757

Active Member
2004 HSE 124k manual

Hello to all, i hope all are well

My car has something strange.....

The gears need a punch to get in, specially 1st 2nd and Reverse, and sometimes all of them.Other times they go in smooth and easy, but its becaming rare. All of them are hard to shift.
But if the car is off, all of them get in smooth and with no problem!!!!!
My clutch works fine it grabs by half and there is no sleeps
What is going off????!!!!
Is it something serious

Many thanks ....DOCTORS
 
IMG_20211008_155823_4~2.jpg
 
Sounds like a clutch issue to me, probably the master cylinder at fault, but could also be the connection between the actuating rod and the pedal.
 
Hello to all and thank you.
HOw can i see the the gear oil ? i replaced the oil 3 months ago.

Nodge so what plan of action should i take to know and sort this problem?
Many Thanks
 
Hello thank you for the answers
Let me see if i can explain.
As 0 all up and 100 pedal down.
You start to feel resistance at 35/40.
The bite point 65/75
Almost like under middle...

I need to check the oil on the master cilinder?
What oil is used?
Many thanks
 
I will try to bleed it.
Is there a bleeding point? A bleeding niple or is just dc from the gearbox ..point that enters the gearbox....??? does the upper cap opens?
I tried Haynes and to look for somebody doing it and i could not find something i could understand or find the bleeding niple
Many Thanks
 
Last edited:
Is the bleeding niple the blue thing on the photo?
Thank You
 

Attachments

  • 000000305359.jpeg
    000000305359.jpeg
    30 KB · Views: 108
It is the bleed nipple. Make sure no debris falls in to the reservoir.
I use an easy bleed kit that has one way valve so I can just top up reservoir and pump it out on my own. Normally 3 slow strokes of the pedal right down per top up.
Don't let the reservoir run out!
I have done mine twice in 3 years.
 
I was thinking on doing reverse bleeding like that i dont even need to open the reservoir .is it better?
 
anubis757 said:
I was thinking on doing reverse bleeding like that i dont even need to open the reservoir .is it better?
Click to expand...
The reservoir is tiny, so you'll not get much fluid before it spills over.
However a reverse bleed will work, if you can take out the excess fluid.
 
Hello
SO i bled the system....some air and dark oil came out.
3 long pedals down.
BUt this morning was starting to get funny again. i did around 60 miles in town and it beahaved so so.
Any way i order new master cylinder must be here in 2 weeks. then i will replace all the fluid.
Any more advices you might have?
Many thanks
 
You must log in or register to reply here.

Similar threads

anubis757
Freelander 1 Please opinions, Ideas, fixes.....
Replies
9
Views
823
andyfreelandy
andyfreelandy
D
2011 sd4
Replies
2
Views
769
Arctic2
Arctic2
anubis757
Freelander 1 Is it worth it!!??
Replies
5
Views
921
Alibro
Alibro
T
Gear selection problem
Replies
3
Views
789
miktdish
miktdish
C
trans fail safe prog
Replies
4
Views
444
courtec
C