G

gazza1591

Active Member
Hi

Got mot in a month or so, just got newnew mig welder (new to welding).
The 2 front inner arches at the bottoms need sorting out, just wondering best way to tackle them would be?
 

Attachments

  • 20150531_201444.jpg
    20150531_201444.jpg
    157.6 KB · Views: 228
+1 for yrm - they are good.

have a nosy at Easy-on panels - alternative, IIRC, slightly thicker steel. They have a fleabay shop.
 
Chop all the bad out and leave it squarish then make templates from card. I'd do the bottom first, one piece folded at 45' and then do the side.
 
Ive dun mine no pics tho. Remove wing then cut out all the rust and then plate in.
 
I done mine about a year ago no pics but easy enough to do take your time measure and then measure it again I made my panels out of some 1.5 mild steel that I had knocking around and as you say your new to welding have a practice on some scrap steel first,
 
Take outer ally wing off then plan your attack. Plenty of grinding discs, sikaflex and mig gas to hand. Yrm stuff is good but not cheap but saves a lot of time and faff. Its still a faff mind ! :D
 
You must log in or register to reply here.

Similar threads

Naf623
Disco 2 What fixings to use for the wheel arch liners?
Replies
2
Views
578
jamesDiscoTD5
jamesDiscoTD5
moorsman61
Sill replacement
Replies
7
Views
1K
moorsman61
moorsman61
currymunster
Disco 1 Front shocks
Replies
16
Views
1K
frostythor
frostythor
PopPops
Disco 2 MOT fail, front body mount
2 3
Replies
58
Views
7K
PopPops
PopPops
O
Disco 2 Where to source used parts?
Replies
1
Views
312
Landmark2
Landmark2