R rj75 Member Jan 30, 2013 #1 When you take off the inlet manifold to clean it on the TD4 is it ok to use the same gasket again or should it be replaced ?. Thanks Rab.
When you take off the inlet manifold to clean it on the TD4 is it ok to use the same gasket again or should it be replaced ?. Thanks Rab.
DefUnct New Member Jan 30, 2013 #2 Clean it and have a look - if it's in good condition it can be used again.
Allyipod Active Member Jan 30, 2013 #4 I would change the gasket for all they cost..I've never reused a gasket....
JC600 Well-Known Member Jan 30, 2013 #5 Allyipod said: I would change the gasket for all they cost..I've never reused a gasket.... Click to expand... There thick rubber seals, not a gasket. And normally look brand new, so don't need changing. But any pressed gaskets, I would not re-use.
Allyipod said: I would change the gasket for all they cost..I've never reused a gasket.... Click to expand... There thick rubber seals, not a gasket. And normally look brand new, so don't need changing. But any pressed gaskets, I would not re-use.
teddywood1 Well-Known Member Jan 30, 2013 #6 and it will cost you about £40 for all of the rubber ones
cox325 Active Member Jan 30, 2013 #7 yup re used mine too. nothing wrong if there looking good. just make sure you cover the ports......its a bugger getting bits/sockets/leaves out!!
yup re used mine too. nothing wrong if there looking good. just make sure you cover the ports......its a bugger getting bits/sockets/leaves out!!
C carcar New Member Jan 31, 2013 #8 If they are in good condition, reuse them,they still can do the job.I've done so myself without any problems.:clap2:
If they are in good condition, reuse them,they still can do the job.I've done so myself without any problems.:clap2: