nick2303
Well-Known Member
one of the bolts holding the inlet manifold on has fallen out.. its the lower one to the front of the injun..
when i put it back in it wont tighten up..
so guess the thread is stripped..
is it possible to just drill it a bit bigger and re tap it n put a bigger bolt in?
or do i have to go the whole helicoil route?
when i put it back in it wont tighten up..
so guess the thread is stripped..
is it possible to just drill it a bit bigger and re tap it n put a bigger bolt in?
or do i have to go the whole helicoil route?