banzia
New Member
Hi Folks,
I am looking for some help with the correct wiring for the ignition switch/lock on my 1995 110.
At present it has a non standard ignition switch fitted, this was on the vehicle when i bought it, I have finally got round to changing it for an original part, however when i stripped it down it became aparent that the terminals on this switch are not the same as the new landrover switch. I think the switch that is currently fitted is from a tractor or similar ignition setup, there is no steering lock as such just the switch and key setup.
At this stage i decided to rebuild and seek advise regarding the correct wiring sequence.
If someone could tell me which colour wire goes to which terminal (1,2,3,4 ect) that would be great.
regards
I am looking for some help with the correct wiring for the ignition switch/lock on my 1995 110.
At present it has a non standard ignition switch fitted, this was on the vehicle when i bought it, I have finally got round to changing it for an original part, however when i stripped it down it became aparent that the terminals on this switch are not the same as the new landrover switch. I think the switch that is currently fitted is from a tractor or similar ignition setup, there is no steering lock as such just the switch and key setup.
At this stage i decided to rebuild and seek advise regarding the correct wiring sequence.
If someone could tell me which colour wire goes to which terminal (1,2,3,4 ect) that would be great.
regards