Pics or it never happened... he tried.
Stone56
Well-Known Member
WhiskyLassie
Well-Known Member
I don't think I have had porridge in 45 years!Morning
Walk had, getting some tyres on the Kuga in a bit. However chilling out and it's that morning for a pot of porridge.
Morning all, off to a craft fair again today. We are booked in every weekend until Christmas now.
Hippo
Lord Hippo
He died about 8 years ago. Lr owned it for the last 5.Must be because Mr bowler died recently.
DevonGuy
Well-Known Member
Be that a turmarter bottom leff? Iv so us boys bin duin it wrong orl these years.Morning
Walk had, getting some tyres on the Kuga in a bit. However chilling out and it's that morning for a pot of porridge.
Think its WL's tongue tasting the porridge
Have a successful day
Morning
Walk had, getting some tyres on the Kuga in a bit. However chilling out and it's that morning for a pot of porridge.
I’ve got the F2 booked today for 4 new tyres, and a full alignment also.
‘‘Tis the day for spending money it seems!
WhiskyLassie
Well-Known Member
I'm getting cross climates 2 on the Kuga like I run on fl2
WhiskyLassie
Well-Known Member
It's a red silicone spoon
Nice.
I go for a more ‘all terrain’ tyre as I do a bit of farm work too. I run the GO15’s on the F1, so thought I’d try something different on the F2 and ordered Wildpeaks.
Mornin
Cloudy bright here but not cold
Had my recently mot'd car inspected by DVSA, done delivery to me miles after mot
One major 'do not drive' fault
Six major mot fail faults
Seven advisories
Off to trading standards now, think the mot garage may be getting points against them.
Stay dry all
Cloudy bright here but not cold
Had my recently mot'd car inspected by DVSA, done delivery to me miles after mot
One major 'do not drive' fault
Six major mot fail faults
Seven advisories
Off to trading standards now, think the mot garage may be getting points against them.
Stay dry all
Ive got stepped drills for this type of work.
Edit I just re-read it so you need to go sideways, when ive done this by putting the drill in the original hole then start to angle
it down & use the middle of the drill bit to take more metal off then use a round file to finish it off.
Last edited:
