Best of luck, hope it all goes OK.Morning All.
Got the paper, and it began to snow on my way back. Just a very light dusting of it in the air.
Today is "Lathe Day".
Have a good day.
Young lad turned up 10.15am saying he's supposed to do 10 square metres, that'll be the ceiling and one wall in my estimation, I'll see how he gets on
Think he's back on here. noticed his style yet again. Think he is now calling himself "Tax Dodgers".
See what you think.
Discovery 2 maf delete
Hi all I do a fair bit of green leaning and keep getting maf sensor wet which is getting to be a pain how do I go about removing it I know it needs mapping out but what mechanical changes need to be made Thanks
www.landyzone.co.uk
Hippo
Lord Hippo
Is 10 his limit per day or per job. Or the description of yer job to be done.Young lad turned up 10.15am saying he's supposed to do 10 square metres, that'll be the ceiling and one wall in my estimation, I'll see how he gets on
Hippo
Lord Hippo
Banned last week.Think he's back on here. noticed his style yet again. Think he is now calling himself "Tax Dodgers".
See what you think.
Discovery 2 maf delete
Hi all I do a fair bit of green leaning and keep getting maf sensor wet which is getting to be a pain how do I go about removing it I know it needs mapping out but what mechanical changes need to be made Thanks
He says 10 sq m to do the job, trouble is plaster's loose in several places all over so really most of it needs hacking off or just knock off the loose and do it with base and finish without the plaster board
That much is obvious, but wasn't obvious is how much they, together with the PO abused this. Until all this came out.
AND once they realised the Horizon system was faulty, they tried to cover it up and stick Bandaids over stuff rather than close it down, rewrite the bits that needed doing and then TEST it properly.
Sadly, so often the case.
If that was him, then he really makes no effort to cover up his style.
Perhaps he does it on purpose and keeps trying to improve on his "personal best " time!
Have a good day all!
Hippo
Lord Hippo
Fink he's getting a kick out ovvit. Years ago some peeps came on ere to visit AG then take the mick int tech sections. Comments like 'dun't bother fixing the brakes. HGF before the month is oot'. Tech sections were ruffer back then. We had 3 active mods to keep us inline. And sometimes mod1 would crawl oot from under his bridge. Fink bob see's the place as being the same as back then. Posts in the style of how it was before years ago.If that was him, then he really makes no effort to cover up his style.
Perhaps he does it on purpose and keeps trying to improve on his "personal best " time!
Stone56
Well-Known Member
Think he's back on here. noticed his style yet again. Think he is now calling himself "Tax Dodgers".
See what you think.
Discovery 2 maf delete
Hi all I do a fair bit of green leaning and keep getting maf sensor wet which is getting to be a pain how do I go about removing it I know it needs mapping out but what mechanical changes need to be made Thanks
Stone56
Well-Known Member
Proving it by the log burnerYer microwave is on fire
Stone56
Well-Known Member
I'm getting that lovely aroma over 'ere!
