SpaceDawg

Active Member

• Jun 4, 2016

• #1

Hello,

Just wondered if anyone can measure from the ground to the bottom of the wheel arch on there 90 for me. Mine seems to be sitting a little high on the front and its bugging me, I'll put a photo up later.

I have 235 x 85 on mine so the measurements can only be from the same size tyres.

Also I did replace the rear springs with OEM standard hight and load, so it might be someone whacked hd one on the front at some time.

 

R

rupert092

Member

• Jun 4, 2016

• #2

Mine is 34 inches from ground to bottom of wheel arch, sitting on 245/75/16 tyres.

 

L

lynall

Well-Known Member

Full Member

• Jun 5, 2016

• #3

Why not measure axle centre to bottom of arch then you can ignore what tyres are fitted?

 

SpaceDawg

Active Member

• Jun 7, 2016

• #4

Good idea, its 50cm from the middle of the axel to the bottom of the wheel arch.

 

Turboman

Mab An Gov

• Jun 7, 2016

• #5

SpaceDawg said:

Hello,

Just wondered if anyone can measure from the ground to the bottom of the wheel arch on there 90 for me. Mine seems to be sitting a little high on the front and its bugging me, I'll put a photo up later.

I have 235 x 85 on mine so the measurements can only be from the same size tyres.

Also I did replace the rear springs with OEM standard hight and load, so it might be someone whacked hd one on the front at some time.

Click to expand...

In the genuine manual there are distances from bump stop to axle all round. The idea is that when they go too low, you get new springs. Might be helpful to you too.

 

Turboman

Mab An Gov

• Jun 7, 2016

• #6

Just looked it up, bump stop to pad on axle should be in excess of 2.8 inches all round, and reasonably similar.