Hi guys, just been over to my mates as he has purchased a Hawkeye Pro (he didn't want to go halves in the end as he said we live too far apart). We plugged in and 17 different faults of which most were historic so cleared when we cleared the DTC's. We were left with three faults which were all the same but one for each of the motors. The fault being " left, right or top blend motor fault _ sc (short circuit) to 12v or other circuit". This would possibly tie in with my manual tests which had no output to any of the motors (tested with meter at plug pins). I have now found out that the previous owner had the controller replaced by his local garage which did not cure his fault on the Hevac (unknown what his fault was).
Has anyone had these faults on any of their motors and if so how was it overcome?
Does anyone know if these faults could be caused if the garage fitted the wrong control module I.E. the later type (I have looked but can find no part number on it)?
Thanks
Dean