Lief Zpring
Well-Known Member
For a heater not to work? Yes, perfectly normal.
doriz
Well-Known Member
Check you haven't got a leaf stuck in the blades
border
Well-Known Member
Must be something stuck in there.
will have a look
Hicap phill
Well-Known Member
No videos.
Spin by hand as bearings may be dry.
Fit a 12v night heater instead
Spin by hand as bearings may be dry.
Fit a 12v night heater instead
border
Well-Known Member
Not sure whats gone wrong with Vid, works my end, will try again.No videos.
Spin by hand as bearings may be dry.
Fit a 12v night heater instead
border
Well-Known Member
will have to try and move things to take a look, took me ages to fit the bloody thing.
That sounds to me like it is trying to seize.
They are a crap design, they run dry, then the oiltite bush seizes to the motor shaft, then the bush spins in the tin housing, and then its shagged!
Flossie
Well-Known Member
Nothings crap on a tratter cos they is awesome..
Nothings crap on a tratter cos they is awesome..
Bloody expensive as well, car and the heater motor!
border
Well-Known Member
Hicap phill
Well-Known Member
I think there is meant to have a sponge ring round the heater to the inlet.
glad you update us with the problems.
glad you update us with the problems.
doriz
Well-Known Member
...as in the collar was fouling the fan wheel - you can get your hand inside the plastic inlet through the wing once fitted to back of the collar. When I did mine iirc I put silicone on it and ended up covered in the blasted stuff. As @Hicap phill says, glad you resolved it, very satisfying.
