Ash2304 · Mar 11, 2017

hi, I have a 90 with a 200tdi engine. I've got a new (second hand) heater box as my original one is seized. Now whoever has removed the old one of the donor car has just cut the cables and my old cables are no good.

I've tried searching for new cables but can only find a heater control cable? Do I buy two of these or are they different cables for the different controls?

Thanks Ash

Flossie · Mar 11, 2017

@neilly
He will know the part numbers

neilly · Mar 11, 2017

Flossie said:
@neilly
He will know the part numbers

Not sure if it is right or not.

But take a shufti at this page.
http://www.allbrit.de/UNI.cfm?PAGE=760853&SPRACHE=EN

Cheers

Ash2304 · Mar 12, 2017

neilly said:
Not sure if it is right or not.

But take a shufti at this page.
http://www.allbrit.de/UNI.cfm?PAGE=760853&SPRACHE=EN

Cheers

Thanks! 16 and 13 look like they should be right. Much appreciated!

lynall · Mar 12, 2017

Once you have fitted the cables, unsnap the cable retaning clip and move the outer cable 1/4 of an inch towards the arm itself then refit the clip this slightly preloads the internal flap making sure its shut and cold air cant bypass the matrix, makes a massive difference to the heat output.

Ash2304 · Mar 12, 2017

lynall said:
Once you have fitted the cables, unsnap the cable retaning clip and move the outer cable 1/4 of an inch towards the arm itself then refit the clip this slightly preloads the internal flap making sure its shut and cold air cant bypass the matrix, makes a massive difference to the heat output.

Thanks for the advice. I've read a lot of posts saying they're rubbish as standard.

lynall · Mar 13, 2017

Yes and Ive posted plenty of comments along the same lines but after messing around with the cables I actually have heat and was amazed as for 5 years Ive been cursing this fcuking car each winter!

flat · Mar 13, 2017

lynall said:
Once you have fitted the cables, unsnap the cable retaning clip and move the outer cable 1/4 of an inch towards the arm itself then refit the clip this slightly preloads the internal flap making sure its shut and cold air cant bypass the matrix, makes a massive difference to the heat output.

What a great tip, cheers

Ash2304

Active Member

Flossie

Well-Known Member

neilly

Well-Known Member

Ash2304

Active Member

lynall

Well-Known Member

Ash2304

Active Member

lynall

Well-Known Member

flat

Well-Known Member

Similar threads