I know this is covered plenty of times but I can't seem to find the specific answer.
So I have a freelancer 1.8 (don't judge me) 03 manual.
My HDC was working, then I took the relay out to test something. (I didn't need it as the switch soldering had gone on the gear stick) Forgot about it, and put it back in 3 months later.
Anyway, today I put a new relay in, and soldered up the switch wires. But its not engaging the HDC!
What I've tested so far....
1) the switch wires are running at 13.5v
2) I've swapped the relays with a working identical
3) I've bypassed the switch to make sure it wasn't the switch
4) Tested the dash light, its fine, comes on with startup check
5) Tested every fuse I can possibly find.
Now I'm stumped, any ideas?
Thanks
So I have a freelancer 1.8 (don't judge me) 03 manual.
My HDC was working, then I took the relay out to test something. (I didn't need it as the switch soldering had gone on the gear stick) Forgot about it, and put it back in 3 months later.
Anyway, today I put a new relay in, and soldered up the switch wires. But its not engaging the HDC!
What I've tested so far....
1) the switch wires are running at 13.5v
2) I've swapped the relays with a working identical
3) I've bypassed the switch to make sure it wasn't the switch
4) Tested the dash light, its fine, comes on with startup check
5) Tested every fuse I can possibly find.
Now I'm stumped, any ideas?
Thanks