mick the builder
Well-Known Member
Am i trying to compete with Gatso's eye to detail? I know its not that critical but Ive finally got round to welding the holes in my chassis rails that put the brakes on my overhaul. As i had to cut a section out of the bottom and sides, the question is, i want to piece in the bottom in one bit for strength but as im keeping all the repairs flush, the joint between the two halfs of the chassis would be missing. Anal i know but one answer would be to run a weld along the middle of the patch meeting up with the joints at either end of it. Anyone else come across this and were bothered?? I want it to be as invisible as possible.