lynall said:

I have no idea, but just done clutch in my 200 and was not to impressed wit the rattle at idle on first start up, now 50 odd miles later it seems to be quiet.

Click to expand...

towsey956 said:

hi all, il try to keep this simple

So my clutch arm/fork got poke thru and I decided while in there to give it the following
-hd arm
-valeo clutch
-spigot bush
-rear main crank seal
-front/input/pinion shaft gearbox seal
I also found and fitted a defender transfer box to compensate for the tyres at the same time

When doing the gearbox seal I removed the end plate with the 2 bearing cups/races in it and found no shims or anything in there so changed the seal and refitted how it was with some sealer making sure the oil ways were clear

However, on test drive the amount of chatter when sat in neutral is unbelievable, non of us have ever heard anything like it, it got a little better but I don’t know if that’s just because it got warmed up but it’s still not good, to the point where I was sat at some traffic lights and people were walking past looking at it so I opened the door and it was echoing across the street!

I see on ashcrofts site that it mentions about new clutch drive plate springs being tight and causing this issue but it’s horrific, really I’m wondering if I could have done something wrong while having the front plate off the gearbox like lost or dropped something even tho I’m sure I didn’t

She’s a 98MY d1 with r380

Any help or advice would be massively appreciated on this

Towsey

Click to expand...

towsey956 said:

I actually spoke to Luke from LOF and was wanting that exact clutch but with all this carry on funds just didn’t allow it. Mines on ATF and was fine until today, my only experience with one on MTF94 was a lad I know who changed onto it because his had quite a few miles so wanted to quieten it down a bit but he did about 10 miles and swapped back to ATF as his gear changes were terrible...but I have thought about trying it if this carries on. If I’m honest I want to be sure I’ve done nothing wrong when changing the box seal

Cheers

Towsey

Click to expand...

towsey956 said:

Hi James great to hear from you

Thanks for that, this clutch does have 6 I think, 3 pairs of different sizes and I do hope it settles because WOW!

What do you know about the running temps of the boxes, I thought they would be similar, and what’s the proper way to do the front pinion seal, or do you think it will be the clutch plate

Thanks

Towsey

Click to expand...

towsey956 said:

Thanks for that
My clutch is only a valeo with the different coloured springs and wasn’t sold as HD but we will see.
I was sure at the time that I didn’t lose any shims although I was a bit surprised to find the lower cup for the layshaft bearing floating around with a snap ring round it rather than being pressed in. I’m only so concerned because I’ve interrupted the gearbox bearings And done a couple of other jobs and now have a noise which I’m sure you understand

This transfer box is new to me, I’ve gone from my 36d to a 43d from an ‘05 110 that came from a friend of a friend but my concern is for a couple of reasons, one being that I’ve had the intermediate shaft loose to do the o rings and found that once the stake nut was unstaked it was actually loose so I just took the slack out and checked for no endfloat, and I also had the input gear out so was hoping that my amount of sealer is adequate for those bearings, the last being that it looks as though someone has had the front housing off before the person I bought it from going by the different and newer sealer and the copper slip on the flange nut so...? I have never paid attention to the temps of the boxes before but I touch3d them both a few mins after it was put on the ramp and the gearbox was warm but the tbox was definitely what can only be called fairly hot,

Thanks again

Towsey

Click to expand...