I have a Dixon 1/4 section which after buying, i realised i didnt need as my chassis is still good. But its a very well made item, looks and feels the part, very heavy duty. Id use them again. He takes ages to deliver but if you are ok with that, no worries. Get it galvanised by them too.
 
Most half chassis are not, that is my issue as the rot starts on the ARB mounts.

The MOT tester said front part is fine and that with all the extras a full swap would take ages (such as all the ACE pipes).

Bits over the tank are basically welded panels, done about 4 years ago. ARB was welded 2 years ago
 
Dunno if this is relevant, but the bloke who welded up my chassis talked about fitting a 1/3 chassis. Obv less than a half, but he said he did them quite often and quoted me a decent price.
:):):)
 
Stanleysteamer said:
Dunno if this is relevant, but the bloke who welded up my chassis talked about fitting a 1/3 chassis. Obv less than a half, but he said he did them quite often and quoted me a decent price.
:):):)
Click to expand...

Would be welding onto poor metal, the ARB bracket have been welded, so I want to replace it hence 1/2
 
You must log in or register to reply here.

Similar threads

S
Chassis change out
Replies
4
Views
291
Stu@69
S
P38 guy
Bent chassis
Replies
13
Views
642
P38 guy
P38 guy
G
Chassis Corrosion - Cause and long-term fix
Replies
18
Views
2K
MJI
MJI
B
bulkhead
Replies
7
Views
575
Dauphproto
D
S
richards chassis & pre-drilled holes for steps
Replies
1
Views
253
hughdavies
H