somervillearron14 · Jul 17, 2020

hi i just bought a 2003 range rover for 1200 pounds the guy put all new suspension on it and still the front end was super extended and the rear on the ground! air sus incative. well i scanned it with my landrover scanner its the front left level sensor. So while im waiting on the part i wanted to use the car so i used two pdfs to manually raise and lower the suspension with just 4 thin pieces of wire nothing else!

ok so you need 4 of the thinnest bits of wire you can find,you need to remove the panel on the passenger side and unplug both plugs from the air suspension ecu then you use the diagram im going to include and you can raise and lower each side manually! took me 3 hours but its driving great! but remember dont plug the ecu back in untill youv fixed your issue or it will go back to the way it was

so i have included the pdfs anyone needs help just message me or email me on somervillearron14@gmail.com

dont worry the worse thing you can do is blow the fuse!

somervillearron14 · Jul 17, 2020

IF ANYONE IS LOCAL TO ME OR WANTS TO TRAVEL TO ME OR IF YOU CANT DRIVE YOUR CAR PAY THE FUEL FOR ME TO COME TO YOU,I WILL RAISE/LOWER/LEVEL YOUR AIR SUPSENSION FOR FREE IF YOU ARE GETTING THE AIR SUS ACTIVE!

ALSO I HAVE THE FULL LANDROVER JAGUAR DIAGNOSTICS I WILL ALSO SCAN FOR FREE AND FIND YOUR EXACT ISSUE FOR FREE!
I PAID 1200 POUNDS FOR MINE WITH ALL NEW SUSPENSION AND BRAKES ALL ROUND THE GUY HAD IT AT 4 GARAGES AND A SUPPOSED SPECIALIST AND THEY COULDNT FIND THE ISSUE I BOUGHT IT AND WITHIN 5 MINUTES I FOUND THE ISSUE IT WAS THE FRONT LEFT LEVEL SENSOR

MY EMAIL ADRESS

somervillearron14@gmail.com

i live in lanark 20 miles from glasgow id prefer if you travel to me but i will travel to you and do it for free if you pay the fuel costs,if you email me ill give you my phone number

Henry_b · Jul 17, 2020

somervillearron14 · Jul 17, 2020

Henry_b said:

i hope this helps some people it took a lot of reading wiring diagrams ect i read a lot of forums people asking the same question,and most people said it cant be done!

its definately a good temporary fix!,only hard part is getting all sides level because i would get one side level then go round the other side and it had went up! took me a few hours to figure it out but anyone with basic electronics knowledge can definately do it and it costs nothing i just used 4 bits of spare wire i had. I was even thinking it wouldnt be hard to put a switch on the wires and leave them on so you could adjust the height to any position you want just by using the switches if you used two standard 12v switches if you press one switch the car will raise and the other the car will lower!

RangeRoller dt · Jul 17, 2020

How much do you charge for this...

Askin fer sum frends

Henry_b · Jul 17, 2020

RangeRoller dt said:
How much do you charge for this...

Askin fer sum frends

I THINK IT IS FREE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

RangeRoller dt · Jul 17, 2020

That’s okay then.

backinblack · Jul 17, 2020

Or you could just use your diagnostics and go to the lower suspension menu

backinblack · Jul 17, 2020

somervillearron14 said:
hi i just bought a 2003 range rover for 1200 pounds the guy put all new suspension on it and still the front end was super extended and the rear on the ground! air sus incative. well i scanned it with my landrover scanner

What scanner have you got?

DanClarke · Jul 17, 2020

I think this is an invaluable service. As in.... it has NO VALUE that you could ascribe to it.

tomcat59alan · Jul 17, 2020

Henry_b said:
I THINK IT IS FREE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Fec all's for free, cash ,gas or ass.nobody rides for free.

somervillearron14 · Jul 17, 2020

DanClarke said:
I think this is an invaluable service. As in.... it has NO VALUE that you could ascribe to it.

actually it does,if your suspension is stuck on low or high like mine was no matter the scanner you have it will still stay inactive not all the time but if you need a level sensor or another part,i was unable to drive my car and i could clear the code with my scanner but it would go back to inactive again when i tried to get it to adjust

somervillearron14 · Jul 17, 2020

tomcat59alan said:
Fec all's for free, cash ,gas or ass.nobody rides for free.

its free it doesnt cost me anything at the end of the day

somervillearron14 · Jul 17, 2020

backinblack said:
Or you could just use your diagnostics and go to the lower suspension menu

i tried that but it would lower but as soon as the key was taken out and put back in the front would go to the highest setting and the rear the lowest it was undrivable

somervillearron14 · Jul 17, 2020

to be clear its just a temporary fix untill you can get it fixed to keep it on the road as you know if the suspension is too low or too high it can do damage and in my case it was dangerous crashing through bumps and rolling in the corners,all i need is a level sensor i have ordered it but i have only done this temporarily so i can actually use my car

if anyone wants it done its 100% free and not permanent everything gets plugged back in but you need to remove the air suspension fuse and as soon as its fixed its just the case of plugging the fuse back in and clearing the codes

backinblack · Jul 17, 2020

Pressing the airsuspension lock button should stop that happening

DanClarke · Jul 17, 2020

@somervillearron14 Take no offense, we's a real pi$$-taking crew con here mate.

backinblack · Jul 17, 2020

Or like you say pulling the fuse

somervillearron14 · Jul 17, 2020

backinblack said:
Pressing the airsuspension lock button should stop that happening

not in my case it doesnt the lights on the adjuster are not lit and the buttons do nothing its completely inactive and was undrivable you should have seen it! the front was super high and the rear super low

somervillearron14 · Jul 17, 2020

backinblack said:
Or like you say pulling the fuse

yeah thats what i said i pulled the fuse but i was unable to adjust the suspension even with the scanner tried everything

Member

Attachments

Member

Think outside, no box required.

Member

Well-Sprung Member

Think outside, no box required.

Well-Sprung Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Member

Member

Member

Member

Well-Known Member

Well-Known Member

Well-Known Member

Member

Member

Similar threads