wickford90 · Mar 28, 2011

Hi all
today got a bad crunching/grinding serious sounding noise from front drivers side, it comes and goes. touching brakes does not change the noise, so dont think its them. noise gets faster in line with cars speed. If its a bearing would it not make a noise all the time? or is it something more sinister and expensive.

jamesmartin · Mar 28, 2011

i think i would check wheel brgs,cv,brake for stone etc

wickford90 · Mar 28, 2011

jamesmartin said:
i think i would check wheel brgs,cv,brake for stone etc

What one is the cv joint

tottot · Mar 28, 2011

The one inside the swivel housing that allows you to steer.[constant velocity joint]

Discoandy · Mar 28, 2011

my latest noise tured out to be a prop uj, but if its at the front then yopu would notice that from about 45mph shaking the steering.

jack up the wheels in turn abd spin them that will give you a clue as were to start.

hext · Mar 28, 2011

Discoandy said:
jack up the wheels in turn abd spin them that will give you a clue as were to start.

+1

then whilst its up, Place your hands at the top and bottom on the wheel and wiggle back and forth, bearings generally a tiny bit of movement, anything over 5mm would suggest the bearings need replacing..

fyne1 · Mar 28, 2011

While checking all bearings spin wheels had one a wee while ago making expensive sounding noises and it turned out to be rust built up inside the disc rubbing on hub as wheel turning.

Station House · Mar 29, 2011

Sometimes there's a cheap & simple fix - but admittedly not often!

If still fitted, check the mud guard isn't catching on the disc - mine had rusted so badly on drivers front that it had collapsed and what was left was catching at the 3 o'clock postion as you look at the disc.

wickford90 · Mar 29, 2011

Just jacked up the front wheel and there is loads of play, as i am moving the wheel you can see the brake disc move also, would this be the bearing ???

jamesmartin · Mar 29, 2011

i would say so but just check its moving in relation to swivel housing disc is bolted to wheel brg hub

wickford90 · Mar 29, 2011

jamesmartin said:
i would say so but just check its moving in relation to swivel housing disc is bolted to wheel brg hub

Sorry to be a bit thick, check what is moving in relation to swivel housing.

Badger · Mar 29, 2011

http://www.landyzone.co.uk/lz/f41/rear-wheel-bearings-renewed-58851.html

http://www.landyzone.co.uk/lz/f41/cv-joint-renewal-68945.html

Buster's guides may help you understand a bit better

[JP] · Mar 29, 2011

thats the wheel bearing for sure...

take the half shaft out and you'll see what's wrong, there's probably nothing left of the bearing

wickford90

Well-Known Member

jamesmartin

Well-Known Member

wickford90

Well-Known Member

tottot

Well-Known Member

Discoandy

New Member

hext

Active Member

fyne1

Active Member

Station House

Well-Known Member

wickford90

Well-Known Member

jamesmartin

Well-Known Member

wickford90

Well-Known Member

Badger

Well-Known Member

[JP]

New Member

Similar threads