norried

Active Member
Ok so I tried to grease my prop shaft today but none of the grease nipples will take grease. I took off the one on the prop shaft slide and it’s definately not blocked. The grease just comes out the side.
So my question is do Land Rovers have a funny size grease nipple?
I’ve just got a standard grease gun with the end that came with it.

Thanks.

Norrie.
 
I've got a couple, both standard, both fit.

Use the edge of a screwdriver or similar to push in the ball valve in the end of the nipple to free it up
 
I removed one nipple and pushed the end in. The grease gun is nearly new so must be worn nipples. Usually you can still pump grease through them though.

Norrie.
 
you might need to hold gun on the nipple square
I have had problems with new grease guns which have been very cheap. I think it is poor manufacturing and have had both too loose and far to tight. As above try holding the gun square and pressing into the nipple.
 
Yeah you could be right. I used to have a really good old one but lost it in the divorce. My new one one just a cheap one. Might buy a new end for it then.
 

Similar threads