Five Pots
Active Member
Bugger bum bollix!
Thanks to Deranged for getting my Genny to me.
Yu was right tho - it is 110volts
You're welcome. I guess you could either use 110volts kit , or pop it bay on the 'bay.?
You're welcome. I guess you could either use 110volts kit , or pop it bay on the 'bay.?
yup
first things first tho - see if it works.
If it does, 110volt cutter/grinder is about 30 squids or so. Transformer is about £100.
first things first tho - see if it works
.If it does, 110volt cutter/grinder is about 30 squids or so. Transformer is about £100.
genny isnt powerfull enuf to weld.
and i can do that at home - only need to cut up away from home.
and i can do that at home - only need to cut up away from home.
Fur Trapper
Banned
Miller weldng make's a 100 volt one works real good 1/8 6011 no problem.Only trouble is.. where are you gonna find a 110v welder
anyone wana swap a 240 volt 3kw genny then :bolt:?
G-man
BBQ king
Only trouble is.. where are you gonna find a 110v welder
US ones will be 110v and i know hss hire out 110v 180a mig welders
stripped complete fuel system, cleaned it all out - it was blocked solid!.
derusted and resprayed the rusty bits.
tried powering it up - it runs and puts out (no load) about 135V AC - woohoo)
it runs a bit lumpy tho and thats, most likely, due to knackered jets and broken gaskets in the carb. Overhaul kit next. Soon be ready to cut up stuff.
.derusted and resprayed the rusty bits.
tried powering it up - it runs and puts out (no load) about 135V AC - woohoo)
it runs a bit lumpy tho and thats, most likely, due to knackered jets and broken gaskets in the carb. Overhaul kit next. Soon be ready to cut up stuff
.
ordered overhaul kit - takes about a week.
I reckon total cost is going to be circa £100. not bad for a fully checked, rebuilt and serviced 3Kw genny .
I reckon total cost is going to be circa £100
. not bad for a fully checked, rebuilt and serviced 3Kw genny .
