S

slimworx

New Member
well just put a new clutch in my 90 and it seems to be a little harder to get in to 1st and 2nd and ideas cheers
 
sounds like its the new clutch dragging slightly 'cos it needs to be bed in for a while.

Drive it for a week or two then try again :)
 
and check the fluid is right up to the mark, mine was paying up and was only a few mill low!
 
i took the engine out to do it and also fitted a slave cylinder and clutch arm i thought it was air in it but seem to have spent agers bleeding it up cheers
 
Do a search on here re. bleeding these things.

I posted something about it not that long ago.

Pour fluid in the top until it runs bubble free from the bleed nipple.

Then get someone to slowly deck the clutch with the nipple open... as they reach the floor tighten the nipple - repeat checking fluid as you go.

At night, jam your clutch pedal down with a stick and leave it overnight this lets the system self bleed.

After a few days it should be fine.
 
You must log in or register to reply here.

Similar threads

T
Gear selection problem
Replies
3
Views
790
miktdish
miktdish
L
2.4 Defender struggling to change gears
Replies
3
Views
828
lawr.i.e
L
seg
Vibration noise and not smooth running
Replies
7
Views
495
1988smithy
1988smithy
A
Name that tune?
Replies
19
Views
767
Anaconda
A
tweedandbriar
A bit jumpy in low revs...
Replies
5
Views
479
dag019
dag019