donk56
Active Member
I have recently bought a 110 csw with galv chassis and bulkhead. Not a complete rebuild.
There are a couple areas which don't line up properly.
As per the title there is a gap which in areas is about 5 to 10mil.
I can't tighten things any further as the plastic fasteners behind are pulling out.
Should there be or can I put in some form of gasket / seal between?
If so what can I use?
There are a couple areas which don't line up properly.
As per the title there is a gap which in areas is about 5 to 10mil.
I can't tighten things any further as the plastic fasteners behind are pulling out.
Should there be or can I put in some form of gasket / seal between?
If so what can I use?