S

splashback

New Member

• Nov 27, 2021

• #1

Hi Everyone, could do with some expertise, bought a 2A unseen a few years ago, mistake I know, and as we are at the final stages of rebuild find that while rear prop shaft is fine my front one is 25mm short, some one suggested its something to do with shackle plate angle.
Any advice much appreciated

 

Attachments

• 
  IMG_0242.JPG

  356.1 KB · Views: 174
• 
  IMG_0245.JPG

  432.4 KB · Views: 187

Blackburn

Well-Known Member

• Nov 27, 2021

• #2

pic of rear of front springs would help is engine actually in place thinking springs not compressed enough.

 

S

splashback

New Member

• Nov 27, 2021

• #3

Blackburn said:

pic of rear of front springs would help is engine actually in place thinking springs not compressed enough.

Click to expand...

 

S

splashback

New Member

• Nov 27, 2021

• #4

Here you go

 

S

splashback

New Member

• Nov 27, 2021

• #5

splashback said:

Here you goView attachment 253462

Click to expand...

Yes engine is in, was difficult with new bulkhead didn’t fit easily

 

L

lynall

Well-Known Member

Full Member

• Nov 27, 2021

• #6

splashback said:

Here you goView attachment 253462

Click to expand...

Is that an old fan belt as a pipe p clip?
I love ideas like that, mate used same belt to repair step plate on his kids wheelchair, have seen others use the flat belts as filter straps.

 

L

lynall

Well-Known Member

Full Member

• Nov 27, 2021

• #7

Ps I cannoot the shackle plates being an issue, yours look fine
Have a measue between the diff and tfer box flange and see what others say theirs measure at?

 

Blackburn

Well-Known Member

• Nov 28, 2021

• #8

Your spring shackle looks fine loosen the rubber boot on the propshaft and check it is extending fully.
What engine have you got fitted that caused issue with bulkhead?
Is the propshaft the original one that was fitted when you bought it or a replacement, if replacement check it is correct part number.

 

mystery

Well-Known Member

• Dec 6, 2021

• #9

you have not crossed the front a rear diffs as the front is slightly longer

 

tottot

Well-Known Member

• Dec 6, 2021

• #10

Diffs are all the same unless the rear is a series 3 one with no filler plug in diff housing, even so difference is small.