ciderman

Active Member

• Jul 2, 2010

• #1

hi
i need to remove my diff to weld up a hole in the front of the pan.
when i am told I could remove the trackrod and split the axle at the swivel ball, what exactly are the bolts to undo?
help!

 

M

mikebeetle

New Member

• Jul 2, 2010

• #2

undo the six bolts holding the swivel onto the axle case. pull the hub and halfshaft out complete. you will also have to disconnect the brake hoses.

 

Spyderman

New Member

• Jul 2, 2010

• #3

mikebeetle said:

undo the six bolts holding the swivel onto the axle case. pull the hub and halfshaft out complete. you will also have to disconnect the brake hoses.

Click to expand...

Careful of the oil seal too, easily damaged.

It's easy enough taking it apart, but re-assembly is a 2 man job really.

 

oxides

Well-Known Member

• Jul 2, 2010

• #4

Think about replacing the swivel seals while you're there - they should just slide over the ball flange.

 

W

w3526602

Active Member

• Jul 2, 2010

• #5

Hi,

No need to pull half-shaft all way out to remove diff, so no need to split hydraulic system. Difficult bit is driving to the welder with dangly half-shafts. Best not to try this.

602

 

oxides

Well-Known Member

• Jul 2, 2010

• #6

.........unless you need to replace the ball to axle gasket 'cos it's gonna break up when you remove the ball....