everton

Member

• Jan 12, 2017

• #1

hi ,going to put a one of these poly bush into center diff mount ,ive changed the mount before but the complete part, ive not used poly bush before . how do you remove the old bush from the bracket and push the new polybush into bracket holder

 

tonytherunner

Active Member

• Jan 12, 2017

• #2

BURN IT .....

 

Arctic2

Well-Known Member

• Jan 12, 2017

• #3

They should come in two half's cut out you old bush then insert and push together the poly bush using a G clamp as below, a little rubber grease also helps

 

Attachments

• 
  SDC14897.JPG

  156.1 KB · Views: 153

everton

Member

• Jan 12, 2017

• #4

Ive not had the bush yet but it dont look like a two part type .

 

everton

Member

• Jan 12, 2017

• #5

Is it hacksaw old bush out then knock it out of the bracket mount

 

Nodge68

Well-Known Member

• Jan 12, 2017

• #6

everton said:

Is it hacksaw old bush out then knock it out of the bracket mount

Click to expand...

Yep. Cut the old bush in half with a hacksaw. It will come out easily, once its tension is removed.
The poly bush is in 2 parts that are pressed in from each side. The steel distance tube is then pushed in

 

Madmustang

Well-Known Member

• Jan 25, 2017

• #7

everton said:

View attachment 115089 hi ,going to put a one of these poly bush into center diff mount ,ive changed the mount before but the complete part, ive not used poly bush before . how do you remove the old bush from the bracket and push the new polybush into bracket holder

Click to expand...

YouTube the question and you will see how the yanks do it. Then pick your preferred method