B bentonrover New Member Jul 22, 2010 #1 Can these be serviced without pulling the hub on a 99 p38 bosch. Trying take down a rough road code. Think its one of the sensors. Thanks
Can these be serviced without pulling the hub on a 99 p38 bosch. Trying take down a rough road code. Think its one of the sensors. Thanks
B bentonrover New Member Jul 23, 2010 #3 Cool thanks so is a pry bar needed. Cause these things are seated good
E eightinavee Well-Known Member Jul 23, 2010 #4 Yes,a pry bar of some kind will be needed.The sensor must be corroded in place,be careful though they are easy to damage.I had one in from a local garage just last week where they had ruined the sensor - I had to sell them another one.
Yes,a pry bar of some kind will be needed.The sensor must be corroded in place,be careful though they are easy to damage.I had one in from a local garage just last week where they had ruined the sensor - I had to sell them another one.
Irishrover Well-Known Member Jul 25, 2010 #6 NO !! That will do the inside of the sensor no good at all