50cc
Member
A lot of people use there Freelander in mondo mode without any problems (apparently).
With a clutch system you would do the same as people who have there Freelander in mondo mode, but with the flick of a switch instead of hours of messing around.
howardo
New Member
Yes but I'm just questioning the bit about 4wd not 2wd. I think that you would still need a vcu in the drivetrain to protect the ird.
Northern Irelander
Well-Known Member
I just received a reply from Ashcroft, sounds positive so far!
Whoohoo!!!
Nicely done, I'd be interested in this, but £500 is still an expensive mod.
If they go for knocked Down kits, could they shave 10-15% off this?
Northern Irelander
Well-Known Member
20 mins actually
Although if you take Dazlanders approach, whereby the rear shaft is removed, tricky with the U- washer, a quick release split pin and castle nut would be handy.
Northern Irelander
Well-Known Member
Agreed, for the early ratio IRD's with 0.8% difference
The later type with same ratios front and back shouldn't be a problem
50cc
Member
20 mins actually
Although if you take Dazlanders approach, whereby the rear shaft is removed, tricky with the U- washer, a quick release split pin and castle nut would be handy.
Still doesn't beat pressing a button
50cc
Member
IRD ratios
I thought only the final drive had an upgraded ratio, as far as I know the IRD has never changed. Or am I missing something?
chromiumuk
Well-Known Member
I thought the difference between the Freelander & other Landies was that the rear wheels were geared to turn slower than the front on the Freelander with the VCU slipping to allow for this on the road, but on the Defenders etc. they were basically geared to turn at the same speed albeit through a centre diff to compensate for different grip levels between the axles, especially offroad. I could be wrong, but wouldn't like to mess around with mechanical or electrical locking of any kind. Should it fail in the locked position, would it not be like having a seized VCU?
Northern Irelander
Well-Known Member
IRD ratios
Here's the ratios, judge for yourself
The IRD ratios changed in 2001-02,
Old IRD ratio - 1.458:1
New IRD ratio- 1.467:1 *(every Freelander from VIN YA999999)
Some of the early FL have different final drive ratios as well:
Petrol engine - 4.200:1
L-series eng - 3.647:1
Td4 engine - (manual) 3.182:1, (auto) 2.910:1
Some new ratios >2001:
IRD input shaft to IRD countershaft - 0.828:1
IRD countershaft to front driveshaft - 1.762:1
IRD countershaft to prop shaft - 0.553:1
IRD ratio > 2001
Td4 - 1.467:1
1.8 - 1.467:1
KV6 - 1.359:1
some iteresting ideas here, i think you would have to keep the viscus unit, an electric clutch would be just the job, cutting a prop is easy and cheep to have done,
the other way or course is to use a dif unit with a locker, this would give the best of both worlds, a stock dif without crown wheel ect could be recased and mounted in place of the vc, you would have 4x4 at all times but with none of the wind up that freelanders suffer with, in deep mud lock it up, for most people an un-lockable dif would be fine
the other way or course is to use a dif unit with a locker, this would give the best of both worlds, a stock dif without crown wheel ect could be recased and mounted in place of the vc, you would have 4x4 at all times but with none of the wind up that freelanders suffer with, in deep mud lock it up, for most people an un-lockable dif would be fine
Northern Irelander
Well-Known Member
You aint priced a new prop then...........good luck!
Chaser
New Member
Think again....
MickO'CTD4
New Member
I was speaking to my brother in law (engineer and land rover crazy, in fact complete fanatic) who had the same idea as nongrokal. He said the simple way would be to use a dif unit with an air locker to get you out of trouble. I shall speak to him more about it seeing as though I am keen and he has good ideas.
Would this not void the insurance though?
He did say though that the VCU was a good idea in principle and it was introduced to mass market so that anyone could drive a land rover (freelander) out of sticky situations.
Would this not void the insurance though?
He did say though that the VCU was a good idea in principle and it was introduced to mass market so that anyone could drive a land rover (freelander) out of sticky situations.
yes i think this may be the way to go, a land series rover dif without the crown wheel and pinoin is not that big, its avalible anywhere and locker kits are easy, a new case would have to be made, the outher way seems to be an electric clutch, these are avalible have yet to sus them out
Chaser
New Member
What part of the 'diff' do you intend using??
