wonder if the rear wiper is in the park position - is it working ok
Also does the 'door open light' go out on the dash when you shut the tailgate?
Open the door ,remove the door card ,open the nuts that clamp the glass in place. Then remove the glass and then the window regulator . you dhould see which cable is broken .You could do a diy job using bicycle brake cable and solder or buy a cable set off ebay lots of sellers .
Keep note of where the cables enter the motor mechanism . Its easy enough .
and welcome .
Is this a "Chicken & Egg" situation ??
Does the window have to be calibrated before the rear wash/wiper will work....Or...does the rear wiper have to be in the Park position before the window can be calibrated ???
Due to the fine weather I have not used the rear wash/wipe for some time but a few weeks ago I fitted a pushbutton switch for the Ronbox in the switch blank to the right of the steering cowl. I remember securing ht cable out of the way of the pedals to some wires behind the dash. Maybe I have disturbed the connectors to the wash & wipe switches on the cowling ????
I will have a look later and post my findings.........:confused2::confused2::confused2:
Decided to see if anything else doesn't work and discovered that the heated rear screen switch is not illuminating, which it did before
Definately something has gone haywire and having hands on experience of working on P38 Becm's, I'm of the opinion more so, that it's the CCU (Body Control module).
I have just arrived at my Sisters in Walsall and it's grub and a few bevvies :5bcheers2:
Will then get the multimeter out tomorrow.
Thanks for all the input and help....really is appreciated
John
I am having same problem but once done and I push rear wiper switch the rear glass stopsI think it must be to do with calibration. i will re-calibrate tomorrow and see if that sorts it. this thread seems to be just my problem:
"TAIL DOOR GLASS OPENS AUTOMATICALLY IMMEDIATELY AFTER CLOSING
Bulletin Number - 0104
Issue - 1
Date - 28.08.2002
Model - Freelander
Affected Range - All derivatives
Re-Issue Information
Problem -
TAIL DOOR GLASS OPENS AUTOMATICALLY IMMEDIATELY AFTER CLOSING
Cause
Tail door glass calibration incorrectly set within the Central Control Unit (CCU).
Action
Where a complaint of the above is confirmed, follow the calibration procedure below to reset the tail door glass.
Calibration procedure
1. Disconnect the battery earth lead. Refer to Workshop Manual, General Information, Electrical Precautions, Battery disconnection.
NOTE: Allow ten seconds to elapse between disconnection and connection to erase the stored calibration value.
2. Connect the battery earth lead.
NOTE: The tail door glass will drop approximately 2 seconds after the battery has been connected.
3. Start engine.
4. Ensure that all electrical loads, i.e. lights, heater etc. are turned off.
5. Increase the engine speed to 1500 rev/min for 10 seconds, after 10 seconds and whilst maintaining 1500 rev/min, carry out the following operations:
Close the tail door glass to calibrate the CCU.
Fully open the tail door glass.
Fully close the tail door glass.
If the tail door glass remains closed the calibration procedure is complete, refer to step 6.
If the tail door glass opens then repeat the calibration procedure from step 1.
6. Allow engine to idle then switch off engine."
I am having same problem but once done and I push rear wiper switch the rear glass stops
Working and have to do it all again any ideas guys much appreciated[
Have calibrated it 4 times so far