It's the Tweeter Cover.
What's wrong with it?
You can use the standard non HK one as a direct replacement, although you might need to replace them in pairs to keep the sound in balance, but I expect there's little difference in the sound between the standard tweeter and the HK one.[/QUOTE
I do appreciate the help you are all providing, The problem is that the top pin which holds the Tweeter Cover on has snapped and the H.K Cover won't hold back on without that pin.
Same here. I glued mine back on too.
That's a common problem.
Mine did the same. I used CA glue to glue the spike back on, which seemed to work.
That's a common problem.
Mine did the same. I used CA glue to glue the spike back on, which seemed to work.
However, I'm sending for that C.A Glue....Thank you so very much for all your help and advice.
This is what I use for gluing plastics.
https://www.ebay.co.uk/itm/17533855...ar=474575568027&widget_ver=artemis&media=COPY
Use the HV type and allow it a full 24 hours to set.
This is what I use for gluing plastics.
https://www.ebay.co.uk/itm/17533855...ar=474575568027&widget_ver=artemis&media=COPY
Use the HV type and allow it a full 24 hours to set.