Hi everyone
I've changed the thermostat housing and coolant rail today as well as the inlet manifold gasket.
I've got water gushing out of the joint between the thermostat housing and coolant rail.
I've the thermostat home into the rail then found the bolts don't line up so pulled it about it.
Looking at the old rail there is either a very worn o ring or silicone inside it.
Does the o ring on the thermostat housing seal the 2 parts or am I missing another o ring?
Thanks again in advance
Kevin
Ps this might be a repeat message as I don't think the first open up loaded properly
I've changed the thermostat housing and coolant rail today as well as the inlet manifold gasket.
I've got water gushing out of the joint between the thermostat housing and coolant rail.
I've the thermostat home into the rail then found the bolts don't line up so pulled it about it.
Looking at the old rail there is either a very worn o ring or silicone inside it.
Does the o ring on the thermostat housing seal the 2 parts or am I missing another o ring?
Thanks again in advance
Kevin
Ps this might be a repeat message as I don't think the first open up loaded properly