good morning everyone,
SO the clutch-2 piece- dual mass flywheel and concentric slave were changed in 2022 September as was master cylinder with a LUK master 4th gear was starting to be getting slightly harder to get into gear I was driving to Poole today and suddenly 3rd became awkward and a bit of a crunch going in then the lot failed/got very awkward to get into gear clutch was holding ok when in gear and pulling away it was just hard to get gears. Managed to get the car home when IParked and switched of there was a bit of a clunk which I have not heard before today also There was a bit of a whine which stopped on pushing clutch pedal which I assume was the release bearing while parked with enine running I could select all gears all be it rather stiff/clunky any pointers? surely it cannot be clutch as it holds ok and pulls away ok??
SO the clutch-2 piece- dual mass flywheel and concentric slave were changed in 2022 September as was master cylinder with a LUK master 4th gear was starting to be getting slightly harder to get into gear I was driving to Poole today and suddenly 3rd became awkward and a bit of a crunch going in then the lot failed/got very awkward to get into gear clutch was holding ok when in gear and pulling away it was just hard to get gears. Managed to get the car home when IParked and switched of there was a bit of a clunk which I have not heard before today also There was a bit of a whine which stopped on pushing clutch pedal which I assume was the release bearing while parked with enine running I could select all gears all be it rather stiff/clunky any pointers? surely it cannot be clutch as it holds ok and pulls away ok??
