I have a low rumble on driving ,then disappears after 2 to 3 miles no grinding or any other noises only a the low rumble ,any ideas
 
Does it have 4 identical tyres? When was the VCU last tasted? Sometimes you get a slight rumble when setting off from cold, especially if no cornering is done before getting to high speeds. This is due to the VCU fluid settling to the bottom, giving an imbalance. This then takes a few minutes to evenly distribute throughout the casing, restoring the balance.
I get this exact thing every morning when setting off for work. After a mile of driving at 50, this slight vibration has gone.
 
Does it have 4 identical tyres? When was the VCU last tasted? Sometimes you get a slight rumble when setting off from cold, especially if no cornering is done before getting to high speeds. This is due to the VCU fluid settling to the bottom, giving an imbalance. This then takes a few minutes to evenly distribute throughout the casing, restoring the balance.
I get this exact thing every morning when setting off for work. After a mile of driving at 50, this slight vibration has gone.
 
Many a vcu fails or starts to fail at around the 60 to 70,000 mile mark, although some last much longer. How many miles has your freelander done?

Col
 
You can get a reconditioned vice and the support bearings for about £300 from Bell engineering. The trouble is if the vcu is knackered and not replaced it will ruin the IRD which is very expensive.

Col
 
The VCU will last much longer if the tyres have always been maintained as per LRs instructions. Mine is still just about serviceable at over 120K miles. If a mix of odd tyres have been used or tyre pressure maintenance isn't kept spot on, the the VCU has a much shorter life as does the rest of the 4X4 system. It's not unknown for an incorrect tyre replacement or a single tyre that's low on pressure to destroy the IRD in a few hundred miles.
 
Last edited:

Similar threads