A

Astin90

New Member

• Nov 22, 2013

• #1

Hello all im after some more help I am looking at fitting a oil pressure guage into my defender 200tdi but to be perfectly honest I dont know were to start, I have looked on the Internet for some help but carnt seem to find clear information anyhelp would be very much appreciated thank you

 

Oldseadog

Well-Known Member

• Nov 23, 2013

• #2

You should find a connection on the oil pump block adjacent to where the oil warning light switch is ... depending on the design of the pump!

If it isn't there you will have to fit a tee piece to fit the switch and the gauge feed pipe.

 

A

Astin90

New Member

• Nov 23, 2013

• #3

Thanks for the reply but isnt the oil pump in the sump?? I already have a guage do I take out the existing oil pressure warning light switch and replace with one that reads the pressure or do I add to it? Thanks

 

jamesmartin

Well-Known Member

• Nov 23, 2013

• #4

Astin90 said:

Thanks for the reply but isnt the oil pump in the sump?? I already have a guage do I take out the existing oil pressure warning light switch and replace with one that reads the pressure or do I add to it? Thanks

Click to expand...

yes you need a y or t piece to allow fitting of both

 

A

Astin90

New Member

• Nov 23, 2013

• #5

Both?? Sorry im a little confused

 

Kwakerman

Well-Known Member

• Nov 23, 2013

• #6

The oil filter housing has the oil pressure switch fitted to it, you remove the switch then fit a T or Y shaped adaptor to where the switch came out. Fit the switch back on to one of the ends of the T or Y and fit the pressure gauge connector to the remaining hole in the adaptor

 

mark-d

Well-Known Member

• Nov 24, 2013

• #7

I just replaced the switch for the gauge, i didn't see the point in the light if i could read the pressure on a gauge

 

A

Astin90

New Member

• Nov 24, 2013

• #8

That's great thanks I best get on eBay now thanks

 

Kwakerman

Well-Known Member

• Nov 24, 2013

• #9

mark-d said:

I just replaced the switch for the gauge, i didn't see the point in the light if i could read the pressure on a gauge

Click to expand...

A light coming on may grab your attention, a slowly decreasing needle may not - better safe than sorry

 

mark-d

Well-Known Member

• Nov 24, 2013

• #10

Kwakerman said:

A light coming on may grab your attention, a slowly decreasing needle may not - better safe than sorry

Click to expand...

its normally to late then anyway

from the nature of my job i tend to keep a close eye on gauges