M

mightymini-5

Member
hi all
i need to tighten up rear wiper arm and clean out rear washer jet
but need to remove finisher panel HOW DO I DO THIS !!!!!!!!

many thanks in advance
shaun
 
Is it actually the washer jet? If you take of the plastic trim from the inside (several self tappers) you'll be able to remove the pipe from the back of the jet, operate it for bit and see if that works, it did for me and the window gets a righ good soaking now.
 
wammers said:
Chassis and body repair. Page 76 Tailgate upper. You may need that off for washer but wiper is tightened from outside. No need to remove it for that.
Click to expand...

thanks but only shows inner panels not top tailgate outer cover

wiper tightenes from out side yes i know but cannot lift little flap over nut enough to get spanner on

cheers shaun
 
Last edited:
mightymini-5 said:
thanks but only shows inner panels not top tailgate outer cover

wiper tightenes from out side yes i know but cannot lift little flap over nut enough to get spanner on

cheers shaun
Click to expand...

Plastic cover slides back off arm to give access to nut.
 
You're not thick mate-I wrestled with mine to fit a new blade and then found the f*** on to change it by the book. I ended up pulling the placcy bit back, repositioning the arm and tightening it up. The trim bit you can remove is at the top of the tailgate, it's still a wrestle, be careful of breaking the reducing connector on the pipe. I had a load of black **** came out of the pipe, the jet was clear!
 
wiper sorted now

washer jet not blocked wife said she could hear pump working

but i think it was not so next to look at pump if knackered or connection

anyone know which one it is or is it just a matter of testing all

cheers shaun
 
well you have a max of 3. blow back from the other end of the pipe and see which 1 blows bubbles. or wash the front screen and that will eliminate 1 of them.

Rave says left looking from front. section 84, washer and wiper system.

have you checked the non return valve in the rear pillar? is that blocked?
 
Last edited:
sas1810 said:
well you have a max of 3. blow back from the other end of the pipe and see which 1 blows bubbles. or wash the front screen and that will eliminate 1 of them.

Rave says left looking from front. section 84, washer and wiper system.

have you checked the non return valve in the rear pillar? is that blocked?
Click to expand...

would pump still not work if this was case cheers
 
Just pull to bloody pipe off and run it, 3 mins max ,if you don't break the connector; including taking the trim off. Don't make it more complicated than it needs to be
 
davef2901 said:
Just pull to bloody pipe off and run it, 3 mins max ,if you don't break the connector; including taking the trim off. Don't make it more complicated than it needs to be
Click to expand...

keep calm mate

have had a play today and found the pump for rear wash not working

took wire off and put it on another and worked other motor

so new pump on order cheers all

shaun
 
You must log in or register to reply here.

Similar threads

A
P38A Rear washer jet pipe 'lost' !
Replies
1
Views
283
cornishboater
cornishboater
J
FL1 Rear washer
Replies
4
Views
563
GrumpyGel
GrumpyGel
C
Tailgate upper finisher
Replies
2
Views
568
Chris_68
C
1
Add heated rear window and rear wash/wipe
Replies
12
Views
1K
shaynecm
S
A
4.4 TDV8 air intake removal
Replies
8
Views
2K
_ASH_
A