Playing around with my new hawkeye this morning and found a fault code which read low air flow with a fault code 3014. Also had a couple of 'injector open circuit faults' which i assume was from when i replaced the injector loom a few months ago?. Cleared all the faults and then went for a drive. The 'low air flow fault 3014' has reapeared. Engine seems to run fine. Any ideas what is causing this fault. Thanks.

Dirty or bad MAF sensor, go to live data on air flow and see value at idle and under full throttle and report, would be good a reading under heavy load too

sierrafery said:

Dirty or bad MAF sensor, go to live data on air flow and see value at idle and under full throttle and report, would be good a reading under heavy load too

Click to expand...

Will do when i get the chance