F

fantotank

Member

• Nov 15, 2012

• #1

I am putting an extra set of rear lights on the Disco ( Led stop/tail/indicators) and a couple of work lights ( 1 each side)on the panel close to the roof join
Can I just remove the screws inside the door frame to remove this panel or is it an interior trim strip to get behind it
Cheers
Chris

 

robint

Well-Known Member

• Nov 15, 2012

• #2

its double skinned in that area , might have a problem putting a nut on back of work lights though !

 

Dr_evil

Banned

• Nov 15, 2012

• #3

Could put the light on a bar instead

 

DEFENDER90-DAZ

New Member

• Nov 15, 2012

• #4

Dr_evil said:

Could put the light on a bar instead

Click to expand...

Like i did

Daz

 

Attachments

• 
  100_2878.JPG

  162.1 KB · Views: 221

F

fantotank

Member

• Nov 15, 2012

• #5

Cheers Guys, din't realise it was double skinned
bollocks...wanted to put the extra rear lamps on there to look neater than a bar..and hide the wiring..oh well off to look at plan 2.( Bar)
Chris

 

Dr_evil

Banned

• Nov 15, 2012

• #6

Well you could go through the door

 

DEFENDER90-DAZ

New Member

• Nov 15, 2012

• #7

You could use rivnuts for the bolts that hold the light bracket on, and drill a hole in each skin for the wires.........

Daz

 

F

fantotank

Member

• Nov 15, 2012

• #8

will there be enough room to drop the cables down to the existing lights between the two skins ?
if I rivenutted the lamps

 

noiseboymart

Active Member

• Nov 15, 2012

• #9

I just bolted work lights through the gutter seam. If you take off the panel with the speakers in then pull back the door opening seal to ease that part of the roof lining away you can fish wires through after popping a hole in the outer skin.