I have a 127 which has had a 300TDi cinverstion and need to change the back section of the box. as it's quite a mo0ngrel I've had trouble trying to get cleear what part I need and I have purchased an Aftermarket ESR2384P from Rimmer Bros which looks the right size and shape

The trouble is the connection bracket to the mid section on the exhaust supplied has 2 bolts at 180 degrees and the one underneath has three bolts at 120 degrees

Also the one supplied has a one side bracket with one side being rubber and the ones underneath had U-brackets (63mm wide 103mm long). Now I suspect I can get these latter items, but I can't see how I can connect the exhaust sections together.

Have I bought the wrong part and is there a conversion kit I can get that would be cheaper than sending this back and buying another exhaust

Regards
Andy

sounds like your trying to fit 200 and 300 and they dont fit buy complete 300 and fit relavant hangers

I'm not keen on fitting a whole new system as everything but the back section are LR original in and in good condition

I have been looking at my exhaust a little more and it starts with 2 hole flanges and finishes with three hole flanges after a section has been cut and rejoined so I suspect someone had the same problem once before and sorted it out with a cut and shut

I've found these on the internet which would save needing to cut my new exhaust (or sending it back), but I can't find a UK distributor showing aything like it


Exhaust Direct Online SFlanges1

Any suggestions ?

Regards
Andy