discomark10
Well-Known Member
O
M
G
:Eek:
M
G
:Eek:
Co-Pang-Yang
Well-Known Member
Hopefully me and Mike will be doing a bit of laning Sunday afternoon to test my 'Fender. All are welcome to join us.
mikeyt
Active Member
We will be there. Any idea where you are going?
How about Violets? Might be a bit damper now.
Sounds like a good idea!! i was thinking the same, and then would be rude not to visit standon ford!
On that pic its just tacked on to the return edges of the crossmember, there is a plate that then fits into the member to tie it all together, you can see it on this pic (and my dodgy painting as well):
Its got 4 plates like this, its not going anywhere this member, just need to rewire the back end, fit the starter and alternator, clutch slave and master, stick up the roof lining, get the washers sorted, fit the boost and oil gauge and mount the rear recovery points... not to much to do then!
Nice one just thought i would mention incase it had not been welded.......
How did you manage to cut the small plates upOn that pic its just tacked on to the return edges of the crossmember, there is a plate that then fits into the member to tie it all together, you can see it on this pic (and my dodgy painting as well):
Its got 4 plates like this, its not going anywhere this member, just need to rewire the back end, fit the starter and alternator, clutch slave and master, stick up the roof lining, get the washers sorted, fit the boost and oil gauge and mount the rear recovery points... not to much to do then!
Jongould
New Member
How did you manage to cut the small plates up
I made 2 more to completely box it in in the end, I added a small drain hole towards the bottom of the replacement chassis sections to allow the water out as its bound to get in somewhere...
There should have been 4 small plates to completely box it in
Jongould
New Member
Ah, I only had 2, I did think that. It don't matter, I used the off cut off from the chassis plates so it's same gauge e.t.c.
This thing will never be moving, the quality is top notch! Well happy with, looking forward to putting it to the test...
Im glad your happy, I bet those other plates are in the back of your van!
Jongould
New Member
Quite possibly, it's a bit of a mess in there, was easy enough to make the plates up...
Co-Pang-Yang
Well-Known Member
probably best I try and get over to Anglia hose in the morning then. 7 connectors for the breather kit isn't it? 3/8th? How many straight and how many 90?
Co-Pang-Yang
Well-Known Member
Well just got in from work gonna shower and head down the barn to put the disco back together and hopefully get the trailer repaired. Fun times.
mikeyt
Active Member
mikeyt
Active Member
6x90deg
Co-Pang-Yang
Well-Known Member
I'll try and get down there if I have enough time.
