muddylane

Member
Hi Everybody
I havent posted for a while as we haved moved back to the UK I will amend my profile asap
The r/r has stood a while, battery did go flat ,recharged on trying to start the engine NOTHING!!! in the past i did on a few occassions have a problem with having to move the gear selector lever to be sure that it was in PARK
HELP PLEASE
Brian
 
Can you turn engine by hand?
are you getting and power to the starter motor?
What car is it?
Bad earth
need a syncmate on it?
 
Hello
thanks for your prompt reply
P38 4.6 HSE AUTO 1995, The car has been stored in a friends barn for 3 weeks drove there no problem, has been moved a few times in the 3 weeks (not by me)just to move other cars around, I am about to go to the Rangie now I will check for power at the solenoid if i can

Brian
 
If all the dash lights come on etc on turning on the ignition, but engine does not crank over, I am with the above view...it is out of sync. Mine did just the same last month. Onto autologic & job was a good un in mimutes. Been fine since.
Good luck.
 
Hi
Yes all dash lights come on, It is a friend that has been trying to move the r/r to his garage to fit the new UK plates etc so i have not tried myself, I know he has some form of diagnostic equipement i am not sure what? Brian
 
Generic obd won't resync the ecu/becm...

As Datatek says above, only dedicated LR diagnostics will do the job.
 
Hi
Sorry for not replying to your earlier question (out at work) but glad Datatek answered you. Have you got sorted yet? If not, why not try asking to see if one of the good members of LandyZone is close to you and has a diagnostic kit & could sort you out for a few beer tokens.
ATB
S.G.
 
goodmorning Bromsgrove defender

Sorry not to have replied sooner, I tried with a mechanic friend (who has some diagnostic equipement but it tells him fault is p16 22 repeated wrong ecm security fault, but he cannot clear it

Brian
 
goodmorning Bromsgrove defender

Sorry not to have replied sooner, I tried with a mechanic friend (who has some diagnostic equipement but it tells him fault is p16 22 repeated wrong ecm security fault, but he cannot clear it

Brian


Yes I know he wouldn't be able to clear it. BUT

Have I missed something here??

Clearing the fault wont solve the problem will it? until the fault has been rectified Shirley??

Would it not start if the fault was fixed, but then just show/log the fault?
 
Yes I know he wouldn't be able to clear it. BUT

Have I missed something here??

Clearing the fault wont solve the problem will it? until the fault has been rectified Shirley??

Would it not start if the fault was fixed, but then just show/log the fault?

Any hard fault has to be cleared for the system to work and this is probably loss of sync.
 
Yes I know he wouldn't be able to clear it. BUT

Have I missed something here??

Clearing the fault wont solve the problem will it? until the fault has been rectified Shirley??

Would it not start if the fault was fixed, but then just show/log the fault?

As far as I understand the problem I had (and many other P38 problems), then yes, clearing faults logged will solve problems.

The fault was loss of voltage. You have resolved that problem, but the fualt has been logged & sync has been lost between the GEMs & BCEM. Clearing the fault & re-sync'ing should sort you out.
I think I am sort of right, but those with a better understanding may be able to put it a bit clearer,
Good luck & keep us in the picture.
S.G.
 

Similar threads