Anyone got the wiring diagrams / instructions for fourby EGT gauge?
https://fourby.co.uk/epages/950004277.sf/en_GB/?ObjectPath=/Shops/950004277/Categories/Defender
Unlike the boost pin, etc it did not come with instructions and emailed / messages, etc a few times with no luck over a week.

Now sat with ferry tickets and gonna have to drive 1500km without it plugged in. there are two wires with it, 5 wire slots and clearly a power entry needed, and one marked resistor?

@battenberg

Any ideas?

Cheers

@cborrman

from fourbys fb page.


Cheers

thanks @neilly !

cborrman said:

thanks @neilly !

Click to expand...

1400 km pretty much flat out and never over 600°C

even 6%+ extended inclines at full whack was holding 80mph on the dial (120km/h on gps) and never went above 601 was highest... previously when I did this trip it went down to 50mph on hills.

Knocked 3-4 hours off a 18/19 hour trip was 15 hours - much more manageable. Interestingly I only refilled twice vs 3 times on last trip... both times just hit reserve on arrival: quite a fuel economy difference with the boost ring/pin and intercooler upgrade. If that is just the pin and ring its paid for itself on one long trip!

amazing how just the boost pin, boost ring and oversized (not full size) alisport intercooler mean the journey time google maps / waze says is now accurate rather than an impossible goal taunting you.

next time will hopefully get time to put ashcroft 1.2 ratio in and will be able to identify which song is on the radio at full whack???