yoda-says

Member
new
• ECU power on reset test

• Reading all ECU fault codes

• Clearing fault codes without resetting the ECU

• Basic status display — water temperature, fuel temperature, throttle pot status, RPM, battery voltage, ECU status

• Throttle display — ECU comms link status, throttle pot status, throttle position (as percentage, a voltage and a bar graph)

• Fuel pump control

• Lambda display— Lambda status, Lambda values, throttle pot status, ECU status

• AFM values

• ECU mapping movement

• Stepper motor / idle valve status— direct control of the stepper motor, valve position

• Idle control — road speed, gear box status, air conditioning status, idle mode on/off, stepper motor position

• Tune resistor values and map selection​
Steve Heath Engineering
ECUMATE 14CUX ECU diagnostics tool

https://shengltd.com/catalog/product_info.php?cPath=287&products_id=275
 
Last edited:
Was just looking at that on his site, cheap considering what it does and only about £50 more than the basic one that just gives a 2 digit code and reference sheet to look it up!
 
Looks good, but I don't fully follow how much better it is than the basic two digit code reading?
please advise ;)
 
Looks like a similar set up to the original Lucas 14cux injection tested with out the control cards
 

Similar threads